The Power Source Profile

The Power Source enclosure is a large triangular design, made to house power points. To achieve this complex look there are many component parts of the enclosure which are bonded and fitted together. The two side panels actually screw into the main body of the enclosure, and when in their original state there are no visible holes. The holes constructed for the actual plug sockets to be placed in are pushouts which allow the same enclosure to suit more than one application. For example in the photo above there is only one pushout removed for the power point leaving the rest of the panel blank.

The design incorporates 5 main cut outs, 2 on each side of the enclosure, and 3 small pin holes on the base. Internally there are 4 pillars needed to support the electronics, and there are a series of inserts to hold the screws in place once the side panels are installed.

For the final design this customer has opted for a metallic dark blue paint application on the exterior of the box. This finish is very distinguishing and makes the enclosure very appealing to the eye. Unfortunately this rich glossy colour can not be fully appreciated through the digital photograph above.

This enclosure was made with 4mm, off white, High Impact Polystyrene, UL94V0, fine grain plastic.

The Original Proposed Design